?Adjustable for a wide range of motorcycles.
?Fit into the external teeth of a clutch hub,Can also be used on gears and sprockets.
?A universal tool for removing many engine variators, flywheels and clutchbells.
?The pins and lock screw enable you to brace the flywheel making removal of variators and clutchbells much easier.
?As with all universal products, they may not fit everything or everything perfectly; but this tool can be simply adapted where required.
?Known Scooter brands this part will work with:
Kymco Scooters 50cc
Sym Scooters 50cc
Piaggio Scooters 50cc
Yamaha Scooters 50cc / 100cc
Gilera 125cc / 180cc
Aprilla Scooters 125
Sinnis scooters 125cc
Vespa Scooters 125cc / 150cc
Lexmoto Scooters 125cc
Nipponia Scooters 125cc
Lifan Scooters 125cc
|Product name||Scooter Motorcycle Clutch Holding Tool|
|Greatest Length||320mm / 12.6″|
|Diameter of Pin||5.2mm / 0.2″|
|Length of Pin||15mm / 0.59″|
|Color||As picture showing|
It works very well
? ? ??The trick is to be very careful not to set the tension tight at all on the clamp…the hubs are aluminum and will crack with to much pressure from the clamp.
? ? ? Just make sure to to turn the knob until is barely snugs up the wrench enough to seat it in the grooves, and be sure to seat the clamps at least 3/4 of the way deep on the hub so there is more surface area to grab which also puts less stress on the hub. Otherwise you could put additinal stress on the aluminum hub if you only clamp around the top edge of the hub.?
? ? ? This tool did it’s job and worked very well…It was able to easily hold the tool and torque the hub to using a torque wrench.